Eagle Group 414-24-3-18R| 3 Comp Sink w/ Side Drainboard| 18in

EAGLE ™ Galvanized S/S Three Compartment Sink With 18" Right Drainboard

Design and Construction Features:
• All bowls have deep-drawn one-piece seamless construction using state-of-the-art hydraulic presses.
• Drainboards, when provided, are integrally welded.
• All sink bowls have a generous radius with a minimum dimension of 3 (76mm) and are rectangular for
maximum capacity.
• Leg locations are adjacent to sink bowls, providing increased stability and maximum weight support
where needed.
• Leg gussets welded to a die-cut heavy-gauge reinforcing plate.
• Entire assembly is fuse-welded and planished providing a one-piece seamless sink unit.
• Welded areas are high-speed belt blended to match adjacent surfaces with continuity of satin finish.
• 10 (248mm)-high full length standard backsplash features 1 (25mm) upturn and tile edge for easy
installation and feathering to wall/splash surface.
• All outside corners of sink assembly are bullnosed to provide safe, clean edges.
• 14 (356mm) water level 17 (432mm) flood level.

Mechanical:
• Water supply is 1⁄2 (13mm) IPS for hot and cold lines.
• Faucet holes are 11⁄8 (29mm) punched on 8 (203mm) centers; two sets of faucet holes are
punched where indicated on schedule.
• Faucets are available as options.
• Basket-type waste drains included fit sink bowls
31⁄2 (89mm) opening and feature 11⁄2 (38mm) outlet.

• 14 (356mm) water level is standard.
• Heavy gauge stainless steel construction bowls are type 304; drainboards and
backsplash are type 430.
• Deep-drawn seamless coved corner bowls.
• Swirl-away drainage.
• Legs welded adjacent to sink bowls for maximum weight support and stability.
• 10 (254mm) standard backsplash includes 1 (25mm) upturn and tile edge for easy
installation and feathering to wall/splash surface.
• Adjustable non-corrosive bullet feet.
• Die-stamped creased drainboards for positive drainage.

NSF-approved installations:
All EAGLE™ sinks bearing the NSF Certification Mark are built in compliance with the National Sanitation
Foundation Standard Number 2.

Material:
• Sink Bowl Heavy gauge type 304 stainless steel.
• Top Drainboards, backsplash and rolled rims are heavy gauge type 430 stainless steel.
• Legs 15⁄8 (41mm)-diameter heavy-gauge galvanized tubing with plated 12-gauge
gussets and high-impact corrosion resistant fully adjustable bullet feet
crossbracing is 1 (25mm)-diameter heavy-gauge galvanized tubing.

Dimensions:
31" x 97.5" (787 X 2477mm) width/length
24" X 24" (610 x 610mm) Bowl Size
18" Drainboard Length

***IMAGE DISPLAYS ITEM THIS ATTACHMENT GOES TO ~ NOT THE ITEM ITSELF***