Powermite Booster Heater
Gas
5 gal storage capacity
Blended phosphate water treatment system
Low water cut-off
Temp./pressure relief valve
Pressure reducing valve
(2) temp./pressure gages
Indicator light & on/off switch
Stainless Steel tank & front
Painted body & legs
195,000 BTU Type: Gas-fired, instantaneous recirculating booster heater with accumulator for use with
door type dishwashers. Unit is floor mounted.
Capacity: PMG-200: Input 195,000 BTUs/Hour. Output 156,000 BTUs/Hour = 45.7 kW
Fuel: Natural gas @ 5 iwc or Propane @ 11 iwc minimum inlet gas pressure. Operating
Water Pressure: 150 PSI max. Relief valve set at 150 PSI, 210F (99C).
Power: Supply 120 VAC, 15 amp service (unit uses 3.0 amps @ 120 volts).
Ignition: Electronic spark pilot with flame proofing by rectification.
Temperature Control: Electronic, temperature control probe/microprocessor based. Factory preset at 190F (88C).
Safety Systems: Energy cut off devices include manual reset heat exchanger high limit and manually reset tank high limit. Redundant gas solenoid valve with integral regulator.
Temperature/Pressure relief valve on tank.
Fluing: Direct combustion air enters bottom, flue gases exit right side or back at top of unit.
Vent: Forced draft system with 4" (102 mm) diameter vent pipe adapter.
Pump: Recirculating with bronze housing.
Connections: Gas 3/4" NPT, Water 3/4" NPT, Electric 120 VAC, 15 Amp.
Products are sometimes shown with optional equipment - material choices and/or finishes may affect pricing for furniture.
Some items may not comply with California Proposition 65.
|
Return To Top
